The following are the maintenance methods of automobile clutch booster for you. I hope they can help you.
1. Because the release bearing has been exposed for a long time and the lubrication condition is very poor, after the tractor has worked for 300 to 500 hours, the release bearing should be removed, cleaned with diesel oil to make it rotate flexibly, and then put it into a container containing butter for heating until the butter seeps into the bearing, and then take it out and install it after cooling and solidification.
2. The clearance between the release claw and the spiral bevel of the bearing cover should be cleaned frequently and lubricated with oil or grease, and oil should be often dropped into the small oil hole on the release claw to lubricate the release claw and the release claw seat.
3. If there is oil stain or rust on the friction plate, driving plate and pressure plate in the clutch booster, it shall be removed and cleaned with gasoline or kerosene, and then installed after drying.
4. After cleaning or replacing the clutch booster bearing, apply proper amount of grease, and make the side with dust cover face the clutch. Do not install it backwards to prevent oil from flowing into the clutch and causing the clutch to slip.
5. Regularly adjust the operating mechanism of the clutch booster, remove the mud, tighten all connecting bolts, and lubricate the clutch booster pedal shaft as required.
6. If it is found that the friction plate exposes the rivet head, cracks, breakage, large area scorching and the thickness of each friction plate is less than 3.4 mm, it should be replaced with a new friction plate.